Hello There,
i have made an Selfmade PCBA with an nRF52810 and it is my first time that i am working with those Chips.
I have used the reference Design for this board and now i am trying to connect my Segger J-Link to the nRF52810.
Everytime i try to connect to my Target with the J-Link Commander i get an error called:
WARNING: RESET (pin 15) high, but should be low. Please check target hardware.
My J-Link Commander is configured as:
SWD, 4000 kHz interface Speed and NRF52810_XXAA as device.
I don´t know what i am doing wrong, i think i have soldered everything fine, have my 32MHz Crystal, have the J-Link 6Pin Needle Adapter to connect it.
Have my external 3.3V for the Chip.
But even when the J-Link Commander tells me this error, why pin 15? In my Opinion the Reset Pin is on Pin 24 and not Pin 15..
I hope somebody of you can help me!