What is the difference between pstorage_store and pstorage_update?

[tumaku]

I am using the pstorage API and I would like to understand what the difference is between these two methods (if any)

[Stefan Birnir Sverrisson]

Hi

Perhaps this thread can be of help?

[tumaku]

Thanks for the link. Just to confirm that I understand it correctly:

• Store can only set bits in flash from 1 to 0, so the area that needs to be modified must be set to 0xFF before
• Clear only works for a whole page and sets all its bits to 1 (all its bytes to bytes to 0xFF)
• There is no way to clear an area/block smaller than a page so before storing any block, the page that contains the block must be cleared
• In order not to lose the rest of the data stored in the page, the page is swaped/backed up through the update command as explained in the previous link.

My doubt is what happens if the chip loses power during the update command. Does the update command implement any recovery mechanism to avoid memory corruption? I do not mind about losing the last updated block but about corruption of the whole flash page