This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Nrf9160DK and SES, cant flash application before debug

Hi

I dont know if this ever worked or stopped working after I updated SES to v4.5

The SES v.4,5 had no nrf support so I had to back down.  (not sure why the update was suggested)

SES also wanted to updated the FW on the usb-swdio bridge on the nrf9160dk, I alloed him to do that.

I cant flash from SES and it wants to do that before debug.
I can flash from the prompt.
I dont know how to configure SES not to download image before debug.

I think the debug works, and it does connect to j-link.

Parents
  • Preparing target for download
    Executing Reset script TargetInterface.resetAndStop()
    Reset: Halt core after reset via DEMCR.VC_CORERESET.
    Reset: Reset device via AIRCR.SYSRESETREQ.
    Downloading ‘merged.hex’ to J-Link
    Programming 32.0 KB of addresses 00000000 — 00007fff
    Programming 120.0 KB of addresses 0000c000 — 0002a027
    Timeout while checking target RAM, RAMCode did not respond in time. (PC = 0x20021160, CPSR = 0x20021168, LR = 0x61000000)!
    Failed to prepare for programming.
    Failed to execute RAMCode for RAM check!

Reply
  • Preparing target for download
    Executing Reset script TargetInterface.resetAndStop()
    Reset: Halt core after reset via DEMCR.VC_CORERESET.
    Reset: Reset device via AIRCR.SYSRESETREQ.
    Downloading ‘merged.hex’ to J-Link
    Programming 32.0 KB of addresses 00000000 — 00007fff
    Programming 120.0 KB of addresses 0000c000 — 0002a027
    Timeout while checking target RAM, RAMCode did not respond in time. (PC = 0x20021160, CPSR = 0x20021168, LR = 0x61000000)!
    Failed to prepare for programming.
    Failed to execute RAMCode for RAM check!

Children
No Data
Related