BLE + FDS Problem to read/write FDS

[Eng Eink]

Hello there;

My setup: 

NRF52832
SDK 15.3

I'm facing some problems with FDS when i use it with BLE activated.

When i read or write on FDS using fds_record_open or fds_record_update with BLE activated i get fatal erros.
But if i dont initialize the BLE the FDS operates normal without any errors.

Some one have any advice about it? I just need to read the FDS on the initialization of the device and write in flash one or two times while the application runs.

Debug:

<info> app: Fast advertising.
<info> app: Event: FDS_EVT_INIT received (FDS_SUCCESS)
(After FDS INIT i try to read the FDS)
<error> app: Fatal error

My BLE Init:

void ble_init(void) {
    bool erase_bonds;
    ble_conn.sts.disconnected = 1;

    log_init();
    timers_init();
    power_management_init();
    ble_stack_init();
    gap_params_init();
    gatt_init();

    services_init();
    advertising_init();
    
    conn_params_init();
    peer_manager_init();

    NRF_LOG_INFO("Modelo esta sendo executado.");
    application_timers_start();

    advertising_start(erase_bonds);
}

FDS init:

void init_flash_fds(void) {
   ret_code_t rc;    
   // Registro p/ receber evento de quanto a inicialização está completa
   (void) fds_register(fds_evt_handler);
   // Inicia flash FDS    
   rc = fds_init();
   APP_ERROR_CHECK(rc);
   // Aguarda o FDS inicializar
   wait_for_fds_ready();    
   // Analisa estado do FDS
   fds_stat_t stat = {0};
   rc = fds_stat(&stat);

}

[Jørgen Holmefjord]

Hi,

Can you build the application with the debug configuration, or with the DEBUG and DEBUG_NRF preprocessor symbols defined? That should help you get the exact error code and location of the error output on the log.

Are you using the softdevice backend for FDS, and not the NVMC backend? The NVMC backend will generate a softdevice assert when trying to write/erase flash.

Best regards,
Jørgen

[Jørgen Holmefjord]

The error you are seeing is FDS_ERR_CRC_CHECK_FAILED. Are you using fds_record_update to update a record before opening the record again? If you are, do you wait for the FDS_EVT_UPDATE event before opening the record?

[Eng Eink]

For now i'm just trying to do these steps for tests:

1st boot of the device:
- init FDS
- fds_flash_write to write a new config
- fds_update to store a value that represent boot count

Then i reset the device and hope to:
- Init FDS
- Open the record <<- Error happens
- Close record
- Update the boot count var

But when i open the record i get the error mentioned before