if boot/reset button, led blinking

[Pepam]

Hi,

I holded boot/reset button  when powering up nrf52832 dk. Now led is flashing. Please how to recover from this state?

thanks

[tesc]

Hi,

Holding the IF BOOT/RESET button while powering up the board makes the interface MCU (Segger J-link programmer chip) on the board enter its bootloader mode. Resetting the board again, for instance powering off and on again, should get it back into the normal state.

In order to probe the status of the interface MCU, you can use J-Link Configurator (which is part of J-Link Software and Documentation Pack.) With that, you can also upgrade the J-Link firmware on the interface MCU.

Regards,
Terje