USBD and nrf5340 QKAAAB 1940

[emag nioj]

Hello, I m developing a device based on nrf5340. On the ERRATA is reported that USBD is not working on QKAA-AB0.

I suppose QKAAAB 1940 is not working too, when do you think to release a version supporting USBD?

Thank you!
Emag 

PS

I m planning to run the nrf5340 in Normal Voltage Mode power suppling 1.8V in VDD and VDDH. When USBD will work do I need to connect VDDH to VBUS or it will be possible to operate with VDDH at 1.8V and VBUS at 5V?

[3dB]

Hi,

was the new revision released as planned? If so, where can I get a dev kit with this new nRF5340? 

I assume that the ones available at Digikey and Mouser are still  the first PDK with the nRF-USB components not mounted due to this bug.

Thanks 

[ovrebekk]

Hi

The new kits should be on the way to distributors these days. 

Unfortunately I have to revise this statement. The new parts and devkits should be available some time next month (December 2020). 

If you check on the distributor page you can also find other distributors in your area that might have stock earlier. 

Best regards
Torbjørn

[3dB]

Ok, thanks.

Are the distributors stocks being updated with the new revision of the nRF5340 itself too? 

[ovrebekk]

Yes. Once the new devkits are available you should also be able to order parts, but supply might be limited initially. 

[3dB]

Found the new dev kit at https://www.rutronik24.com/ Estimated delivery 30/11. 

Thanks

[ovrebekk]

You welcome, good to hear you found it