Unknow source of Noise on SAADC input

[Noon]

Hello,

I need to read resistive sensors values with SAADC. These sensors going throught multiplexer and amplifier.
Infortunaly, the signal going into the SAADC is noisy. It seems to be radio event, but when i use a radio_notification flag, the noise is'nt synchronized with the radio ON/OFF events. I'm sure my sensors acts as an antenna, but i can't find the source of this noise. Any idea?

[Håkon Alseth]

Hi,

 

Do you have anything happening in your firmware every ~90 ms (seems to be the period between the noise)? For instance a SPI/TWI clock signal, which is routed next to this analog signal?

Is there any load on this pin? If yes, how much?

 

Kind regards,

Håkon

[Noon]

Thanks for your reply! Nothing in my firmware is set up to 90 ms. The same noise happening even if i stop all activity on the SPI bus. The problematic pin is P0.03 of DK52, wich is connected on the output of an amplifier (MAX9939).

[Håkon Alseth]

Have you tried to isolated where the noise comes from, by trying to scope other inputs to the amplifier?

Is the noise present if you disconnect the output of the amplifier from the P0.03 pin? Could it come from the Vcc?

 

Kind regards,

Håkon

[Noon]

It seems that the noise comes directly from sensors, as i was thinking, my resistive pannel act as antenna. If i disconnect P0.03 from the amplifier output, it's the same problem. Vcc is also clean. 

I have already done this hardware with other dev boards (not BLE), and i never had this kind of noise before, it's why i was thinking about radio interference. 

The picture of the zoomed noise looks like radiated frequency modulation to me, more than a capacitive coupling of high speed digital tracks. But, the frequency of noise is about 1 MHz, so i don't know where this comes from (my probe is not RF, but the bandwith is supposed to be 25MHz).

[Håkon Alseth]

Have you tried connecting a small cap on the input (between input and GND; 100pF ish, and do the same on the output for that matter) to see if this removes the noise source?

 

Kind regards,

Håkon