Set nRF52840 DK as Sleepy End Devive (SED) in CLI Example included in nRF5_SDK_for_Thread_and_Zigbee_v4.0.0

[Simone Lombardo]

Hi All,

Since I measured a very current consumption by testing CLI example (ftd/usb) I'd like to know how to switch my  nRF52840 DK as Sleepy End Device.

Any suggestion?

Thanks a lot,

Simone.

[Marjeris Romero]

Hi Simone,

Referto Jørgen's answer in your previous case: https://devzone.nordicsemi.com/f/nordic-q-a/61414/high-current-consumption-in-thread-cli-example/250187#250187

You can use CLI command "mode n" to lower power consumption in sleep, should work fine. Keep in mind that the CLI examle is not optimized for current measurements (since CLI runs HFCLK and other peripherals).

Best regards,

Marjeris