This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

exit from debug mode (S110)

Hi,

I'm using the softdevice s110. The power consumption is sometimes a little weird (around 1 mA). I think that the chip is in debug mode. How can I know if the chip is really in this mode ? In this case, is it possible to disable this mode by using NRF_POWER->RESET?

Thanks

Parents

0 ting² over 10 years ago

Hello, Sorry for the late answer. We found out it is a hardware problem on our system. Thank you for all your answers.
Cancel
Vote Up 0 Vote Down

Cancel
0 Jason over 9 years ago in reply to ting²

Hi, ting, what does the "hardware problem" mean ? a pull down register on the SWDCLK pin?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Jason over 9 years ago in reply to ting²

Hi, ting, what does the "hardware problem" mean ? a pull down register on the SWDCLK pin?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data