Ceramic antenna and touch switch placement

[Evgeni]

Hello.

We are currently developing PCB design of smartwatch with RF Nordic nRF24 chip, Johanson small ceramic antenna (P/N 2450AT42B100), and capacitive Touch Switch (AT42Q1012). PCB size is very small: 17x38mm. In PCB one side is placed LCD and Touch Switch pin and on the other side all electronic components and Li-ion Polymer battery. I think that the antenna can affect the switch and inadvertently turn on/off the system.

Here are various options for antenna placement on the PCB. I have no experience with RF.

The question is where to place the antenna so as not to get a random system on/off. 

Thanks.

Evgeni

[awneil]

Evgeni said:

AT42Q1012

Did you mean  AT42QT1012?

That's a Microchip (formerly Atmel) product - nothing to do with Nordic:

http://ww1.microchip.com/downloads/en/devicedoc/40001948a.pdf

For support with that, you need to contact Microchip.

Evgeni said:

I think that the antenna can affect the switch and inadvertently turn on/off the system.

What makes you think that?

Or are you saying that you're getting "random" switching, and guessing that this might be the cause?

If that's the case, surely the first thing to try is to disable the touch sensor ... ?

Evgeni said:

I have no experience with RF

A common mistake is to under estimate the peak currents drawn by radio transmitters, so an inadequate power supply browns-out during these "spikes" ...