I am following https://infocenter.nordicsemi.com/topic/sdk_tz_v4.1.0/thread_border_router.html with raspberry pi 3B+ and NRF52840DK as NCP for boarder router connected over UART (Jlink USB Port) and another NRF52840DK with Thread CLI example for test boarder router. After power ON raspberry pi after few seconds LED1 blinks for few seconds and stay steady after that.
On NRF52840DK with CLI firmware after thread start command LED1 blinks for 1-2 seconds and stays steady afterwords but I am not able to get ping response.panid 0xabcd
Done
> ifconfig up
Done
> thread start
Done
> state
router
Done
> ping 64:ff9b::0808:0808
Done
> ipaddr
fdde:ad00:beef:0:0:ff:fe00:e800
fdde:ad00:beef:0:771e:8086:187:98aa
fe80:0:0:0:4f3:4787:93e9:6115
Done
>
After that I tried with Thread topology manger and NRF52840 with Thread CLI Hex no thread device found.
01:40:18.146 Boot up Thread Topology Monitor
01:40:21.755 Serial port COM9 has been successfully opened.
01:40:24.872 Successfully verified Thread CLI device.
01:40:24.875 Configuring Thread CLI device..
01:40:24.994 Successfully configured Thread CLI device. Joining to the network..
01:40:30.116 Successfully joined to the network.
01:40:49.136 Error - No response from Thread CLI device.
01:41:06.125 Error - No response from Thread CLI device.
I am using latest OTBR image RaspPi_OT_Border_Router_Demo_v4.1.0-1.alpha, CLI and NCP hex from nRF5_SDK_for_Thread_and_Zigbee_v4.1.0_32ce5f8 SDK and nRF_TTM-win32-x64_0.13.0 forThread topology manager.
So how to debug this or any suggestion to get ping done.
Another thing I want to ask is I want to measure current consumption of sleepy end device in thread network and latency to/from message between SED and FTD for evaluation purpose. Can anyone guide me as I am new to thread, how can be setup made for both tests in terms of required number of DK with which example Hex file and anything else required in setup I do have power profiler kit so that I can do that but I need help in thread network setup for both test.
