• State Not Answered
  • Replies 5 replies
  • Subscribers 75 subscribers
  • Views 777 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 250830
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Getting started with Eval board

SidPrice

I have just received my nRF52 development board and I have tried to program one of the pre-bjui;t examples (Blinky). The USB drive on the board appears and if I drag the hex file for the board (10040) onto the drive, the file copies but nothing occurs on the board. The file remains visible until I restart the board.

I was expecting the file to be flashed and the example to run. Pressing buttons does nothing.

Parents
  • 0

    Karl,

    I am using the examples\ble_peripheral\ble_app_blinky\hex\ble_app_blinky_pca10040_s132.hex. I drop the file onto the JLink "drive". I see the file copied to the drive. The file stays visible on the drive until I cycle the power, then it is gone. On startup the eval board turns on LED1, it does not blink.

    I think the SDK version is nRF_MDK_8_27_0.

    Sid

Reply
  • 0

    Karl,

    I am using the examples\ble_peripheral\ble_app_blinky\hex\ble_app_blinky_pca10040_s132.hex. I drop the file onto the JLink "drive". I see the file copied to the drive. The file stays visible on the drive until I cycle the power, then it is gone. On startup the eval board turns on LED1, it does not blink.

    I think the SDK version is nRF_MDK_8_27_0.

    Sid

Children
No Data
Related
Terms of service