This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Softdevice RC LF Callibration Side Effects using other interrupts?

Hi all,

If using the RC LF instead of a 32.768KHz crystal are there any side effects of the 16ms calibration period which occurs every 4 seconds? I'm mostly concerned how other interrupts I'm firing from the timers and adc (not a lot, about 6Hz) could effect the calibration, but also whether the calibration uses any timer perpherials other than RTC0 and RTC1 which are already consumed by it.

Cheers,

Andrew

Parents
  • Hi,

    Not seen or heard of any issue no. This is fully done by hardware really, and no tight timing requirements that affect application or calibration itself.

    Best regards,
    Kenneth

Reply
  • Hi,

    Not seen or heard of any issue no. This is fully done by hardware really, and no tight timing requirements that affect application or calibration itself.

    Best regards,
    Kenneth

Children
No Data