Nrf52840 cli

[sivaguru]

• What are the set of commands to send data from node (router or end device )  to leader through router,(not directly connected);                                                  in openthead cli mesh build example in https://openthread.io/ ,it is given procedure to send data only to visible nearby connected devices (link local)
• In that example both link link local and mesh local are same since all three devices are visible to each other, thought they have used mesh local address

[Edvin]

Hello, 

The thread stack will take care of retransmission of the packets that aren't within reach of the device, so it doesn't matter if the device is in "Link Local", "Mesh-Local", or "Global", for that matter. The mesh stack will take the device address as an input.

From the test description of the CLI example, it says: "For a complete list of CLI commands, run the help command".

[sivaguru]

• I would prefer to build network using eui24 command

https://codelabs.developers.google.com/codelabs/openthread-hardware/#8

           And make communication with UDP mode

https://codelabs.developers.google.com/codelabs/openthread-hardware/#12

[sivaguru]

If a node gets reset , due to power failure, if stared again , does it need to be commissioned again to rejoin the mesh , if the mesh network is built using eui24 command (i.e. in hand shaking mode )

[Edvin]

I don't believe that the eui24 command has anything to do with the network keys. If you get a node reset with the prebuilt openthread stack, the node does not need to be commissioned again. The network data is stored in flash. So unless you change anything crucial in that matter, you don't have to commission it again after a power failure.

[sivaguru]

Another doubt, does usb cli example work for uart command (i.e does uart instances are enabled in usb example)