Thread cli

[anguru]

Does commands 

>Thead down           and

>Ifconfig down 

Commands are equivalent to power failure reset of node in mesh network

[anguru]

I am using eui64 commands to comission the mesh node, if power failure occurs at a node , when the node restarts , is it necessary to commission the node again or will it connect to mesh automatically??

[Jørgen Holmefjord]

The OpenThread stack stores persistent network data automatically in flash. You should not need to recommission the device after a power failure/reboot. However, you need to make sure that the firmware does not use the default masterkey and on boot (most of our examples use autocommissioning and use default masterkey from OpenThread).