Application update with mesh sdk

[attila-v]

HI,

I want to update the application FW in mesh sdk environment from flash memory. The new binary is in the flash memory already (I received it from a spi-ethernet interface). My plan is that I force the mesh protocol to recognize the received FW in the flash bank, then reboot board with calling the 'nrf_mesh_dfu_bank_flash(NRF_MESH_DFU_TYPE_APPLICATION)' function.

I started the mesh with 'nrf_mesh_dfu_request(..)' without problem (where I told to mesh the flash bank address), but the 'nrf_mesh_dfu_bank_flash' function returns with error message 5. It means, there is no valid flash bank.

My question is, how I tell to mesh, that the flash bank is valid?

nrf52840 with nRF5 sdk

Attila

[Joakim Jakobsen]

Hi.

So the new binary is already on the target board?
Is that the only device you want to update, or do you want to update other devices as well using Mesh DFU?

[attila-v]

Hi,

thank you that you deal whit this problem.

yes, the binary is in the flash of the target board, and I'd like to update only this device.

I tried to communicate with the mesh bootloader, which will validate the binary, but I think I have to send more info to it.

[attila-v]

it's almost ready.

I added a new 'dfu_packet' message struct to the application and to the bootloader, which contains (I think) all necessary data for the update. After the bootloader received the data, it loads them to the 'm_transaction' static struct, then it calls the 'dfu_mesh_finalize()' function. The result is that the bootloader erases the application memory, writes the binary into the right place, more times changes the device page area, then restarts itself. After restart the application does not start correctly, but I can see, that the new application wanted to start.

not so easy....