BME680sensor i2c with NRF52840 or nrf52832

[BBA]

I am new to BLE and nordic do you any sample  code for configuring the BME680sensor  i2c with NRF52840 or nrf52832 ?? like GAP and GATT 

[Simon]

We have two SDK's that supports the nRF52840 and the nrf52832, the nRF5 SDK (the one we've used for many years now) or the nRF Connect SDK (this was released around two years ago). You should do some research on DevZone and the documentation and decide which one fits your needs. If you have questions about this, please create a new DevZone case and ask.

Down below I've attached some links for the two SDKs:

nRF5 SDK

• SEGGER Embedded Studio Tutorial (I recommend you to go through this tutorial first if you're using the nRF5 SDK)
• Introduction to Nordic nRF5 SDK and Softdevice
• Bluetooth Low Energy tutorial series
  • Bluetooth low energy Advertising, a beginner's tutorial
  • Bluetooth low energy Services, a beginner's tutorial
  • Bluetooth low energy Characteristics, a beginner's tutorial

nRF Connect SDK (NCS)

• NCS tutorial series
• NCS Getting Started
• NCS BLE tutorial part 1: Custom Service in Peripheral role
• NUS on NCS: The Nordic UART Service with the nRF Connect SDK

---

Regarding the BME680sensor and i2c with NRF52840 or nrf52832, we can come back to that when you've gone through (some of) the tutorials above and have a good understanding of the BLE part.

Best regards,

Simon

[BBA]

will come throgh and come back