Using a Segger JLink Pro Ethernet connection with nrfjprog

[MarkDickson]

Hello,

I can connect to the Segger JLink plus device using USB but when I try to connect to a Segger JLink pro via Ethernet, nrfjprog I receive the following message " There is no debugger connected to the PC.".  I can connect to the debugger using the normal JLink tools. Using the following command "nrfjprog.exe -i" with an Ethernet debugger connected results in no returned device.

Best regards,

Mark

[haakonsh]

I'm not sure if nrfjprog supports ethernet out of the box.

Have you configured the J-link according to chapter 6.3 "Setting up the IP interface" in the JLink User Guide?