Using a Segger JLink Pro Ethernet connection with nrfjprog

[MarkDickson]

Hello,

I can connect to the Segger JLink plus device using USB but when I try to connect to a Segger JLink pro via Ethernet, nrfjprog I receive the following message " There is no debugger connected to the PC.".  I can connect to the debugger using the normal JLink tools. Using the following command "nrfjprog.exe -i" with an Ethernet debugger connected results in no returned device.

Best regards,

Mark

[MarkDickson]

[MarkDickson]

Hello,

Since nrfjprog.exe does not support the Segger Ethernet interface, I need to translate the following commands so I can use the Segger flash tools to program our parts. Can you please provide this translation?

nrfjprog.exe –recover

nrfjprog.exe --family NRF52 --program MyFIle.hex –chiperase

nrfjprog.exe --family NRF52 –reset

[Kenneth]

Not sure if I have the details, but you may find this case and documentation useful:

https://devzone.nordicsemi.com/f/nordic-q-a/33911/what-are-the-raw-jlink-exe-commands-sent-by-nrfjprog-exe 
https://devzone.nordicsemi.com/f/nordic-q-a/64566/failure-to-eraseall-via-nvmc-access-from-segger-jlink 
https://infocenter.nordicsemi.com/topic/nwp_027/WP/nwp_027/intro.html

Kenneth