• State Not Answered
  • Replies 5 replies
  • Subscribers 67 subscribers
  • Views 6335 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 106529
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nRF51DK to program custom board

TheGodPartycle

i have the nRF51DK that comes with the Segger j-link programmer. Can i use the programmer on the board to program a custom board i purchased from Nordic preferred vendor? the module has the VCC, Ground, SWDIO and SWDCLK pins exposed.

are there any resources available that indicates how to program a custom board that uses nRF51822?

Parents
  • 0

    i have this board. the question is, how exactly can i use this to program and debug a custom board? image description

    the nRF51DK has Debug in and Debug out. I am assuming i have to use debug out on top left hand side as shown in the picture below.

    questions :

    1. Where can i purchase a cable that fits into the debug out socket?
    2. how do i tell the debugger to program the external board and not the on board module?

    thank you

Reply
  • 0

    i have this board. the question is, how exactly can i use this to program and debug a custom board? image description

    the nRF51DK has Debug in and Debug out. I am assuming i have to use debug out on top left hand side as shown in the picture below.

    questions :

    1. Where can i purchase a cable that fits into the debug out socket?
    2. how do i tell the debugger to program the external board and not the on board module?

    thank you

Children
Related