• State Not Answered
  • Replies 5 replies
  • Subscribers 63 subscribers
  • Views 6155 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 106529
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nRF51DK to program custom board

TheGodPartycle

i have the nRF51DK that comes with the Segger j-link programmer. Can i use the programmer on the board to program a custom board i purchased from Nordic preferred vendor? the module has the VCC, Ground, SWDIO and SWDCLK pins exposed.

are there any resources available that indicates how to program a custom board that uses nRF51822?

Parents
  • 0

    From Section 5.10 in the nRF51-DK - User Guide:

    The nRF51 DK board supports programming and debugging of external boards. To debug an external board, connect to the Debug out (P19) connector with a 10 pin cable.

    When the external board is powered, the interface MCU will detect the supply voltage of the board and program/debug the target chip on external board instead of the on-board nRF51422.

    You can buy the cable here.

Reply
  • 0

    From Section 5.10 in the nRF51-DK - User Guide:

    The nRF51 DK board supports programming and debugging of external boards. To debug an external board, connect to the Debug out (P19) connector with a 10 pin cable.

    When the external board is powered, the interface MCU will detect the supply voltage of the board and program/debug the target chip on external board instead of the on-board nRF51422.

    You can buy the cable here.

Children
No Data
Related