Hi all,
I've got some code running on my nRF9160dk that is behaving oddly. LED 3 blinks as expected (2 seconds on, 1 second off) but GPIO 10 (pin 18/ULTRASONIC_TRIG) remains at 3v (VDD_GPIO). My code,
void main(void) {
_gpio = device_get_binding("GPIO_0");
if (_gpio == NULL) {
printk("Error Initializing GPIO\n");
} else {
printk("GPIO Initialized.\n");
}
gpio_pin_configure(_gpio, 4, GPIO_OUTPUT_HIGH); //p0.04 == LED3
gpio_pin_configure(_gpio, ULTRASONIC_TRIG, GPIO_OUTPUT_HIGH);
while (1) {
//Maintaining High
gpio_pin_set(_gpio, ULTRASONIC_TRIG, 1);
gpio_pin_set(_gpio, 4, 1);
k_msleep(2000);
// Go low go low
gpio_pin_set(_gpio, ULTRASONIC_TRIG, 0);
gpio_pin_set(_gpio, 4, 0);
k_msleep(1000);
printk("Triggered.\n");
}
}
In addition to this, i have a `nRF9160_pca10090ns.overlay as follows (hangs over from before I removed everything out to diagnose this).
&uart0 {
status = "okay";
current-speed = <9600>;
tx-pin = <9>;
rx-pin = <19>;
rts-pin = <0xFFFFFFFF>;
cts-pin = <0xFFFFFFFF>;
};
Lastly, for sanity's sake, my prj.conf
CONFIG_SERIAL=y CONFIG_TRUSTED_EXECUTION_NONSECURE=y CONFIG_UART_INTERRUPT_DRIVEN=y CONFIG_MAIN_STACK_SIZE=4096 CONFIG_STDOUT_CONSOLE=y #CONFIG_GPIO=y #debug CONFIG_DEBUG=y CONFIG_LOG=y # Segger RTT CONFIG_USE_SEGGER_RTT=y CONFIG_RTT_CONSOLE=y CONFIG_UART_CONSOLE=n CONFIG_LOG_BACKEND_RTT=y CONFIG_LOG_BACKEND_UART=n CONFIG_BSD_LIBRARY_TRACE_ENABLED=n
Thanks in advance for your help :)
