This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nRF52833_DK_DMT_fail

Hi

I am new on nRF52833 and want to try RF test for development.

I have a nRF52833_DK on hand with Direct Test(DTM) in nRF Connect(Descktop). However I am not success.

Please share your comment for RF test for development.

BR

Parents
  • Hi,

     

    The DK needs to first be programmed with the direct_test_mode for your specific board.

    Since you are trying to target the pca10100 board (nrf52833), you can find a precompiled hex file for this DK in our nRF5 SDK:

    ..\nRF5_SDK_17.0.0_9d13099\examples\dtm\direct_test_mode\hex

     

    You should program the direct_test_mode_pca10100.hex to your DK.

     

    When this is done, power cycle the board and you should be able to select it in the drop-down menu in the nRF connect direct test mode application.

     

    Kind regards,

    Håkon

Reply
  • Hi,

     

    The DK needs to first be programmed with the direct_test_mode for your specific board.

    Since you are trying to target the pca10100 board (nrf52833), you can find a precompiled hex file for this DK in our nRF5 SDK:

    ..\nRF5_SDK_17.0.0_9d13099\examples\dtm\direct_test_mode\hex

     

    You should program the direct_test_mode_pca10100.hex to your DK.

     

    When this is done, power cycle the board and you should be able to select it in the drop-down menu in the nRF connect direct test mode application.

     

    Kind regards,

    Håkon

Children
Related