UART/Serial Port Emulation over BLE problem

[Marry]

Hello.

I am following this tutorial, but unfortunately I am stuck at step 7. I am not sure which characteristic corresponds to the UART RX characteristic value. 

I tried writing in different characteristics, but nothing is received by the nRF board (i.e. in putty, there is no update).

Do you have an idea why? Thanks! 

[Amanda Hsieh]

Hi Marry, 

Reflash service in the menu as

Then you will see:

-Amanda H.

[Marry]

Hi Amanda Hsieh and thanks for the idea. However, my menu is different:

 here you can see no refresh available.

I can only refresh the "device", but that is with the disconnected board: 

And therefore, it does not make any difference. 

[Amanda Hsieh]

Hi Marry,

Marry said:

I can only refresh the "device", but that is with the disconnected board: 

Reconnect the device and Reflash service again.

-Amanda H.

[Marry]

I did that. I erased the board and reloaded the code. Then I tried with my phone, closed the app, reopened it, etc.

Still, nothing is changed.

[Marry]

Problem solved: I tried with another phone.

I had problems with nRF Blinky App, but never experienced nRF Connect problems with this phone (Samsung A7 2018), until now. 

Anyway, thanks for your quick help.