how to upgrade nrf51822-beacon kit using nrf51-dk

[shinho]

Hi, I bought the nrf51822-beacon kit and nrf51-dk including TC2030-CTX-NL connector for connecting them each other through the Debug out pin on the nRF51-DK.

I can't find right source code and don't right compile way using the Keil-uV.

I need step by step explanations. I searched serveral days to solve this. No right materials.

Need helps.

[Sarah]

@martinbl Hi Martin, I'm doing exactly what you're saying to program the beacon kit (using the TC2030 connector to connect), but the beacon kit just does not get recognized by the DK, I can only upload to the DK. I measured the voltage on them at it's about 2.8-2.9V. Is there really no way to power the beacon from the DK. Why does that not work and what would you suggest I do to get the beacons recognized?

[shinho]

Hi Sarah, Check as following,

1. You have to put the coin battery to the BK (PCA20006). It makes for the DK board to recognize the BK by comparing voltage differences between the DK and BK. It is very important.
2. Connect the DK and BK with TC2030-CTX-NL connector as you know.

Try it again. You can down load to the BK. That's all. Good Luck.