JLink wont connect after bootloader program

[JD-PPC]

Using Segger with PCA10056 as a debugger connected to a pcb with a NRF52840 on it. Been working fine and I tried building open bootloader and programmed it. I see the device as a com port now and its visible with nrfconnect. I can no longer connect to it with jlink though. Error says no idcode detected. How do I get this back to a state where I can debug my app again with jlink? 

[Simonr]

Hi

I'm sorry, what device is it that you've put into bootloader mode and that is now visible as a COM port? Have you put the DK into the BOOT mode by holding the IF BOOT/RESET button on the DK? In that case you will have to flash the Interface MCU firmware back onto the DK by dragging and dropping the .bin file downloadable here into the BOOTLOADER window that pops up when powering up the DK.

Best regards,

Simon

[JD-PPC]

The device I cant connect to is a fantel BT840 which has a nrf52840 ic in it. I was trying to test the open bootloader. I can see the device in device manager and it connects with nrfConnect. I am not trying to alter anything on the DK board. That works fine and I am able to connect to a different BT840 with it. Just trying to bring my first DK840 back to life. 

[JD-PPC]

Not sure if it was clear, but I am using the DK board jlink debugger to hook up to a another board through the debug out connector on the DK board.