AN36 question

[michurin]

this is quote from AN36> 4.2 Set up

The nRF51822 Evaluation Kit is needed for this application example. However, it is possible to modify the project to also work with the Development Kit. 4.2.1 Setting up the Evaluation board Since the nRF51822 Evaluation Kit has an onboard SEGGER chip, you can connect the Evaluation board through a USB cable and immediately start working on it. 4.2.2 Setting up the application A lot of boilerplate code is needed to get started creating an application and a service, so the first step is to copy code from the SDK:

1. Go to Board\nrf6310\ble\ble_app_template folder.
2. Copy this folder to Board\pca10001\ble\ and rename it to ble_app_lbs.
3. Inside the Arm subfolder of ble_app_lbs change the name of the project files from ble_app_template to ble_app_lbs.

At the same time AN36 has folder code[u][/u] which includes ble_app_lbs.uvproj

Could someone please clarify.

The second question/clarification is where can I find parameters SD110 used on pca10005 and pca10004 for keil?

Thank you.

[Ole Morten]

The ble_app_lbs folder that is included with the application note is a finished project, with all the code that is explained in the document. If copied to the folder explained in the document, it will work as described, but for learning, I'd strongly recommend you to work through the document step-by-step. When having done so, it might however be useful to compare your solution with the finished one.

As for the differences between PCA10004/PCA10005 and the PCA10001, this is only the pins used for buttons and LEDs, meaning that it is sufficient to make sure those are correct depending on your board. The default ble_app_template uses the correct pins by default, so just take care not to replace them and use some other button and LED for LEDBUTTON_LED_PIN_NO and LEDBUTTON_BUTTON_PIN_NO.