Flash Memory Issue

[Muqarrab]

Hi,
I have written these 3 functions to erase/read and write.

/////////////////////////////////////////////////////////////////////////////// SNV

const uint32_t f_addr = 0x000FF000; // Last page start address 255

// Create a pointer to that address
uint32_t * p_addr = (uint32_t *)f_addr; //cast f_addr to a pointer

uint32_t erase_SNV()
{
    NRF_LOG_INFO("Memory Erased");
    return sd_flash_page_erase(255);
}


uint32_t write_SNV(int address,uint8_t value)
{
    uint32_t val;
    val=value;
    NRF_LOG_INFO("Data Write in Flash");
    ret_code_t err_code;
    err_code = sd_flash_write(p_addr+address, &val, sizeof(val));
    APP_ERROR_CHECK(err_code);
    return err_code;
}

uint32_t read_SNV(int address)
{
     NRF_LOG_INFO("The Data read from flash is: %d", *(p_addr)+address);
     return *(p_addr)+address;
}

When I write any value from address 1 it gives following wrong output(0 1 2 3).

    write_SNV(1,11);
    read_SNV(1);
    write_SNV(2,12);
    read_SNV(2);
    write_SNV(3,13);
    read_SNV(3);

  //  read_SNV(0);
    read_SNV(1);
    read_SNV(2);
    read_SNV(3);

 



But When I start address from 0 it gives the right values.

    write_SNV(0,10);
    read_SNV(0);
    write_SNV(1,11);
    read_SNV(1);
    write_SNV(2,12);
    read_SNV(2);
    write_SNV(3,13);
    read_SNV(3);

    read_SNV(0);
    read_SNV(1);
    read_SNV(2);
    read_SNV(3);

How can I save values in rondom addresses?
Thanks!

[Simonr]

Hi

Have you set the DEBUG define in your preprocessor definitions? This is necessary in order to see any of the debug logging information in your log backend. To do so, right click your project in SES, and open Options..., then set the build configuration to Common, find the Preprocessor Definitions tab, and add DEBUG to the bottom here. See the attached picture for reference.

Best regards,

Simon

[Muqarrab]

Hi Simonr,
I have already defined this.