UART to Peripheral

[SKo]

Hello, we want to establish a UART communication between the Dynastream N548M8CB Module and a TI Mikrocontroller. I have tested the UART loopback example with the pca10028 board. It worked fine. How can I adapt the code for pca10028 to the N548M8CB module? Is it possible to use the "DM_LOG(" funktion?

[Susheel Nuguru]

Hi Sko,

In the example you mentioned can you comment out this below line

#define ENABLE_LOOPBACK_TEST

and see if that test compiles and works fine for you. You do not need to connect UART TX and RX if you are not running this example as a loopback. Instead you need to open a serial emulator on your PC to test it. If it still works then APP_LOG should be enough for you

#define APPL_LOG                        app_trace_log 

[Susheel Nuguru]

did you have same pins connected to Segger chip if not how did you solve this?