Recieved Gatt timeout error when tried to generate a read request event

[ref]

I'm trying to create a read event whenever a certain characteristic is read. I used  BLE_GATTS_EVT_RW_AUTHORIZE_REQUEST event to monitor that. I also set "is_defered_read" to true in the code as shown below tot the service initialization code:

add_char_params.char_props.read = 1;
add_char_params.char_props.write = 1;
add_char_params.is_defered_read=1;
add_char_params.read_access = SEC_OPEN;
add_char_params.write_access = SEC_OPEN;

the problem is that when I do that, NRF_connect freezes for a few seconds and then gives me "Gatt timeout error"

If I remove "add_char_params.is_defered_read", the code works normally again.

I'm not sure what I'm doing wrong here. I appreciate any comments.

Thanks.

[Simonr]

Hi Reza

Sorry, seems like I misunderstood the defered_read setting. It should work as intended if you set the rd_auth bit in ble_gatts_attrib_md_t as well as all the parameters you've set in your initial ticket.

Best regards,

Simon

[ref]

Hi Simon,

Just to help me understand, how would you modify this service: "components/ble/ble_services/ble_lbs/ble_lbs.c" in order to activate read authorization events?

Thanks,

Reza

[ref]

Hi Simon,

Sorry for multiple posts. I just found what the problem was. I make a mistake when I copied Vidar's example. I copied the whole example and it worked. 

Thanks again for your help and support

Sincerely,

Reza