nRF Programmer 3.6.0 + Segger J-Link Ultra+

[dhandzic]

I want to use nRF Connect v3.6.0 Programmer and Segger J-Link Ultra+ in order to program our board. I can connect to the J-Link but receive an error message:

The Segger version is 6.86e

Any ideas how to analyze the problem further??

[dhandzic]

I have stepped back to Segger 6.86d and rebooted the computer and now it works

[tesc]

Hi,

I am happy to hear that you found a working workaround. It may have been an issue with the particular Segger version, in combination either with our SoC or with the particular programmer.

Regards,
Terje

[chucklink]

I have similar problem with V6.84a J-link.  Nothing change.  The nagware somehow updated the Nordic and now it does not work at all on any of our boards DK boards.  

[dhandzic]

Hi,

I am still 6.86d without any problems. The Nordic Toolchain is a bit unstable and I have just lost functionality of the LTE Link Monitor after updating to 1.1.9. It is also very sensitive in case you are using a VPN. At least during update and installation you have to turn of the VPN (NordVPN in my case) in my experience otherwise it might be a total mess.

Hope that might help!

[dhandzic]

I have updated to nRF Connect 3.6.1 and Programmer 1.4.8 and Segger JLINK 6.88 and the problems are back!

Programming the same board from the 1.4.1 Toolchain Manager SES works fine!