Trying to initiate SPI calls SystemReset

[muhkuhns]

Hello,

I am currently trying to write my frist few lines of code.. I started with the ble_uart example and then mixed in some code from the spi_master example.. I wanted to try to communicate with a Sensor over SPI and to make sure it works, use UART.

But my code won't work and I haven't yet found out why. I will keep on searching but probably one of you could easily point out the problem.

It seems that after

/* Clear waiting interrupts and events */
    p_spi_instance->p_nrf_spi->EVENTS_READY = 0;

this is called:

NVIC_SystemReset

But I don't have a clue why.

Feel free to have a look at the attached main.c (Of course the uart_init call should be before my printfs.. but thats not the cause of the problem)

[muhkuhns]

I set optimisation to the lowest possible level (0) and now the last line before the reset is:

APP_ERROR_CHECK(sd_nvic_ClearPendingIRQ(p_spi_instance->irq_type));

I searched and searched and looked into my code and finally I found this question here: devzone.nordicsemi.com/.../

Looks like it has to be initialised AFTER ble_init. At least the ble_uart example part is working again now ;-)

[Susheel Nuguru]

It did not give any errors to me. This is strange when you say other people has faced this. Anyways I will close this case for now.