Can not enter application after readback protect?

[Susan_cfx]

Hi ,

I wirte a python script to download FW to nRF52832 custom board, the FW is the merged file with softdevice（s132_nrf52_7.0.1_softdevice.hex）, bootload, bootload settings, and application,  then setting readback protect. 

After setting readback protect, our board just advertising DfuTarg，it seems enter bootload, didn't enter application.

the python script is as follows,

api = LowLevel.API("NRF52")
    sleep(1)
    try:
        api.open()
        api.connect_to_emu_with_snr(jlink_serial, swd_speed)

        # Program the parsed hex into the device's memory.
        test_program = Hex.Hex(hex_file_path)
        print("Writing %s to device..." % hex_file_path)

        for segment in test_program:
            api.write(segment.address, segment.data, True)

        api.sys_reset()
        api.go()
        api.readback_protect(2)   # or api.write_u32(0x10001208, 0x00,True)

        api.pin_reset()
        api.close()

If I comment out api.readback_protect(2)，our board can enter application and works ok .  
In addtion, I download the same FW with nRF connect Programmer, our board can enter application and works ok.
I download another FW, which is merge file with eddystone example，bootload,softdevice, and bootload settings,
it has the same problem，always enter the bootload, attached please find this FW.
1602.ed_sd_bl_set_app.hex

Please help analyze the reason, thank you very much.

[Susan_cfx]

Hi Vidar,

Any update or  suggestions ? thank you very much.

Susan

[Vidar Berg]

Hi Susan,

It sounded like the problem was more intermittent earlier, even when you didn't enable readback protection.  Have you seen any failures now after you added the delay? Also, are you using the same J-link debugger when you use nrfjprog/nRFconnect?

Best regards,

Vidar