nrf52810 programming problem question

[Yclee]

Hello.

I am programming the NRF52810 breakout board.

Before I am testing the prototype, I am using NRF52832 breakout board, and it works well now.

However, the same code(project solution) cannot be programmed.

cf) I am using the pca10040 project, and I think that NRF52 board using pca10040 version.

Should I change some configuration or setting when I will program NRF52810?

In the SES, Target-Connect J-Link is well connected. The error message and debug log is like below.

[Eugene Yu]

Hello,

It seems to you have the wrong configuration of the memory map and using the wrong Softdeivce.

The nRF52810 has 192kB Flash and 24kB RAM.

But in your log, it shows accessing out of the range.

To solve the issue, you need to modify the memory map for nRF52810 and use the correct Softdevice.

Please refer to the Compatibility Matrix, Developing for nRF52810

and Highly recommend you referring the PCA10040e projects in SDK.

[Yclee]

I will show the memory configuration & map and modify including the link.

I don't think about memory structure(size) before..

Thank you very much for your reply.

Best Regards,

Yclee