Power consumption on nRF Connect SDK v1.4.0 Zephyr on nRF52832 DK

[Eirik Aa]

I have compiled the example application ncs\v1.4.0\zephyr\samples\boards\nrf\system_off configured for the nRF52dk_nRF52832

This example consumes 450-500uA (SB9 cut).... 100times more than I would expect. Is there no power optimization when using zephyr? Performance like this would make any project based on this source base flop or fail the say it kindly... Might I be doing something wrong or is the nRF Connect SDK this bad compared to the nRF5 SDK

[Hakon]

Hello,

System off should work the same whether you are using Zephyr or nRF5 SDK, it's the same registers that are being written to. My guess is that the nrf52 is not in system off for some reason. Did you make any modifications to the example code? Can you share?

[Eirik Aa]

Here is the project ( from the SDK folder ) and the board files.system_off.zipnrf52dk_nrf52832.zip

I get a static 420-500uA power consumption

[Hakon]

Have you checked the output log? It should indicate if the device fails to enter system off.

[Eirik Aa]

I have not enabled the RTT: I updated some stuff that should not matter. Not at least after reopening the project I not get a floor power consumption of average 5,7uA. Way better than 450 but still not where I would expect

[Eirik Aa]

Don't needed the RTT.

But when I did this  ( got the out goping with the reset btn ) then floor average ends up at 19,5uA ?!?!

[Hakon]

Eirik Aa said:

But when I did this  ( got the out goping with the reset btn )

 You did what? I don't really understand what this means.