We bought 4 NRF5340 PDK and trying to setup BLE mesh.
As suggested in the getting started guide, there are two BLE mesh example samples from nordic and zephyr.
However, for common BLE examples, it is said that before building any example it is better to program hci_rpmsg to the network core. But it is not mentioned how to configure for BLE mesh examples.
I was able to run BLE mesh light example once but afterward, the board was not recognized in mobile even after rebuilding.
When I tried to flash other board with BLE mesh light control or light switch build error halts the process in "lc_pwm_led.c": 'unsupported board: PWM-led0 device tree alias is not defined".
I would like to know how to correctly set up the BLE mesh light control and BLE mesh light on the board. Following the getting started guide is incomplete.
Other questions like, how to reset the mesh light back to an unprovisioned state after once provisioned.
If we are using nordic BLE sample examples 'light, light control, light switch', is there any guide that how to add more resources such as SPI/i2c, ADC to the same.
Do nordic BLE mesh example uses soft device or HCI of zephyr. What should be the correct configuration to get sample BLE mesh light-light control running?
Thank you.
