This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nRF52811 replacement over nRF52832 plug-and-play ?

Hi,

Our entire board is running around a nRF52832. Recently it has been difficult to find some of these SOC. Is it safe to replace it with the nRF52811 without changing the board layout and the firmware ?

Thanks !

Top Replies

ketiljo over 5 years ago +1

The pinout of the two is the same, so you can replace one with the other. But you need to re-compile the FW for the new device. Any radio certifications will have to be done again as well.
ketiljo over 5 years ago in reply to StephaneJ +1

The nRF52811 have less RAM, hence the placement of the stack will be different. Even if it's equal on the outside, there are differences in the inside. Memory mapping etc.
Simonr over 5 years ago +1

Hi There are a few more steps to take into consideration when switching which board to build an application for. Please check out the developing for nRF52811 guide here on the Infocenter and follow the…

Parents

0 Simonr over 5 years ago

Hi

There are a few more steps to take into consideration when switching which board to build an application for. Please check out the developing for nRF52811 guide here on the Infocenter and follow the "Transferring project to nRF52811 hardware guide.

Best regards,

Simon
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Simonr over 5 years ago

Hi

There are a few more steps to take into consideration when switching which board to build an application for. Please check out the developing for nRF52811 guide here on the Infocenter and follow the "Transferring project to nRF52811 hardware guide.

Best regards,

Simon
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data