Hi to all.
I am new to this forum and to the Nordic range of products.
My experience over the last few months have been with arduino and Feasycom bluetooth modules. I will now venture into the Nordic range of BLE modules with my limited experience.
After buying the BM832E evaluation board and DK board I have decided it might be best to find and expert in this and to spend my time better on other things like pcb design and 3d printing.
I am aware that most of the steps required for this can be done with any of the nrf52 range modules and that the developer doesn't necessarily need the BM832E module in order to do this.
I am looking for person (enigneer/expert) to develop the BM832E module for me. By this I mean set it up and program it.
It is bluetooth ble home control system controlled by a Android app.
Upload/modify my arduino uno code to go onto the BM832E module. My code contains the millis function and uses UART for communication.
It's a basic code to control some lights and the code must not be altered except if you need to address the registers directly or outputs. The millis function must remain!
It should also have NFC pairing. I am not sure how many and if changes are needed in my code for it to be able to work on the nordic module.
Once this module have been configured and programmed the developer would have to give me a step by step instruction on how to setup my evaluation and DK board in order
to upload the code on my side and test it with my BLE app.
For most of the people on this forum it would sound very basic and easy but if you don't have the experience and know how then it's difficult until you have past the learning curve.
