Write and read flash using sd_write_flash and sd_?

[brianreinhold]

I want to use the SoftDevice APIs to read and write flash on the nRF51822. Are there any examples of how to do this. I see all kinds of mixes between pstorage, NVIC (not sure what that stands for) and the softdevice APIs. I did read that if SoftDevice is enabled one should use the SoftDevice APIs. I will be using soft device and lots of soft device BTLE APIs.

However, I don't see any examples of how to do this using JUST the soft device APIs. There isn't even a read method, just write, protect, and erase. Its probably somewhere in the documentation but the search engine is so bad you have to know exactly what you want and what it is called to get anywhere with it.

I want to save and restore pairing/bonding info in the same manner I do it on the PC using the pc-ble-driver. Therefore I do not want to use any of the SDK methods.

[Henry_Chou]

No need to use the SD ( softdevice) . Please refer the example code 

\nRF5_SDK_17.0.2_d674dde\examples\peripheral\flashwrite

You may access the NVIC by your own.

[brianreinhold]

I have read throughout this forum that the other methods will have conflicts if you use SoftDevice and BTLE (of which I use both), at least for the nRF51* series. It may no longer be true for the latest versions of the SDKs and the nrf52* series. The latest SoftDevice I can use is s130 and the latest SDK is 12.3.0

[Marte Myrvold]

Hi,

You can't use NVMC directly when Softdevice is enabled. The explanation for this can be found in this documentation about Flash memory API.

However, you can use fstorage and Flash Data Storage (FDS) to write to flash. fstorage provides functionality to store data to flash and erase flash pages, and is used on top of Softdevice flash API. FDS is used on top of fstorage, and used to minimize the risk of data corruption, and it simplifies the interaction. With FDS, data will automatically be placed at the end of flash (or under the bootloader if that's programmed to the device).

Best regards,

Marte

[brianreinhold]

So what you are saying is that both fstorage and FDS are using SoftDevice to write to flash. I see how SoftDevice is writing to flash. There is a clear method for that.. What I don't see is how SoftDevice reads from flash. Are there any examples using SoftDevice that write and read from flash? Just an example that writes a buffer of data to flash and then reads it would be nice.

Again, this info probably exists in the documentation somewhere but the search engine is so minimal one will never find it. The search engine didn't even find the word 'wait' when it was right in the text on the very page I was viewing. So I have to post far too many questions in this forum.

[Marte Myrvold]

Hi,

I'm afraid we don't have any dedicated flash example using the Softdevice in SDK 12. However, the Softdevice API is rather simple if that's what you want. You can use sd_flash_write and sd_flash_page_erase.

Best regards,

Marte