NO_MEM error with multi-peripheral BLE connection case questions

[Yclee]

Hello,

I am tested multi-channel BLE peripheral connections.
(ble_app_uart example with saadc example.)

When I am testing 2-channel, it works well.

However, when I am trying to more than 3(final goal is 4),

NO_MEM error is occured in

ble_nus_chars_received_uart_print function.

I am try to size up the RAM(size, start address) but it doesn't work.

And I am finding the MTU size or other setting, I don't know which parameter or variable should be modified.

Thanks for reading my quesions.

Best Regards,

Yclee.

[Yclee]

The error message is like below,

<error> app: Failed sending NUS message. Error 0x4. 
<error> app: ERROR 4 [NRF_ERROR_NO_MEM] at C:\Users\yclee\Desktop\nRF5SDK160098a08e2\examples\ble_peripheral\nrf52-ble-app-uart-c-multilink-master\main.c:240
PC at: 0x0002F54D
<error> app: End of error report

[Yclee]

Also, When I increased the TX and RX buffer(256 to 512) it still doesn't work.

[Simonr]

Can you confirm that you edit the TX and RX buffer sizes by changing the following defines?

#define UART_TX_BUF_SIZE 512 /**< UART TX buffer size. */
#define UART_RX_BUF_SIZE 512 /**< UART RX buffer size. */

Also, what nRF52 series device are you using? The only thing that should limit the buffer sizes is the RAM itself, so it could be that the memory is full if you're using one of the lower-end modules (in terms of memory). You should also check the size of your attribute table (NRF_SDH_BLE_GATTS_ATTR_TAB_SIZE). You can try increasing this to see if that helps as well.

Best regards,

Simon

[Yclee]

I am using nRF52832 DK module with master module, 

and the buffer size changing by the defines as you mentioned.

So, I will check the attribute table, and reply the results.

Thank you for your reply Simonr.

Best Regards,

Yclee.

[Yclee]

The 

NRF_SDH_BLE_GATTS_ATTR_TAB_SIZE

is 1408 and I changed 1600 but still no_mem error 

when 3-peripheral module is connected..

Should I change the tab size more bigger?