Firmware Update over UART Interface

[Jatala]

Hello,

Background: I have a custom board that contains nRF52832 module and exposes UART pins (RX, TX, RTS, CTS). I have developed an application using nRF5 SDK v17.0.2. The application does not use any so -called SoftDevice.

Objective: I want to develop a mechanism to update the application firmware of on the nRF52832 module over the UART interface from another micro-controller.

Seeking Help: After searching through the SDK and the forum, it looks like I have to use libraries under Bootloader and DFU modules But I am still confused which components to use and in what order. On the nRF52832 module, do I need to program, as part of my application, routines to receive and process DFU commands/data packets. I am also using the same UART port to exchange application data (from sensors attached sensors )  with the other micro-controller.

I would appreciate any help that can get me started on the right path to achieve the objective.

[Hung Bui]

Hi Jatala, 

I would suggest you to get started with our uart bootloader located inside examples\dfu folder. There are 2 options, secured DFU and open DFU. It depends on your need you can choose to use one. 

The DFU example allow you to do DFU via UART from either PC (nrfutil.exe on PC) or from external MCU (official example is not included). 

I have made an example of doing DFU from one MCU to another MCU here.

I would suggest to get familiar with these resource first, so that you can do DFU from one MCU to another MCU. 

What's missing here is to combine that to your application. What you want to achieve may be accomplished by implementing a command to switch from your application to the bootloader and from there the bootloader can receive the image and update the application. The limitation is that your application will be stopped when the bootloader receiving the image. But the advantage is that you only need to switch to the bootloader, and don't need to modify anything. 
Another option is to implement background DFU where your application will receive the image and then only switch to the bootloader to swap the image. This would require some implement on your application code to receive image that we don't have example code for now. 

Note that the bootloader, when not to be used with the softdevice would need the MBR to be flashed to run. Please refer to the bootloader documentation. 

[Jatala]

Hi Hung,

Thanks for the insight. I will go though the sources that you have pointed out and will come back to this thread if stumbled upon any issue.

The first approach seems simpler to implement. "...implementing a command to switch from your application to the bootloader and from there the bootloader can receive the image and update the application", so in this case, the bootloader will be responsible to receive the application over the UART. But how the configuration and registration of the UART will be handled. I suppose it has to done from my application, right?

[Hung Bui]

Your application would only handle the command to switch to the bootloader, the bootloader will handle from there. 
You need to define your own custom command for that. 

[Jatala]

That is clear now, thanks. So the bootloader will be configured to use the UART as a transport layer and associated UART port configuration (pins, baudrate, etc.).

[Hung Bui]

Correct, that should be handled by the bootloader. It's already implemented like that in our current serial bootloader in  examples\dfu.