nrf52833 beacon messages

[Muhammad Usman]

Hi All!

Hope you all are doing well ! . I am new to nrf52833. My requirement is test the range test with CODED PHY @125kbps /S=8 .

For this i tested the example "ble_app_att_mtu_throughput". It worked fine!  . Now i want to send beacon messages from the

"1st NRF52833" and receive those beacons to another "2nd NRF52833" without point to point connectivity using "coded phy".

Can any one help me in this regard ? Thanks in advance .

[Simonr]

Hi

Please check out this case where my colleague Hung suggests the easiest way to port any pca10056 project (nRF52840 DK) to pca10100 (nRF52833 DK).

Best regards,

Simon

[Muhammad Usman]

Hi Simon 

Thank you so much for the support !

Best Regards,

Usman

[Simonr]

If we can close this case, please let me know by verifying one or more answers in this thread you found helpful, to let users in the future with the same question can easily find what they are looking for.

Best regards,

Simon

[Muhammad Usman]

thank you for your support !

i just port the pca10056 project to pca10100 as per the instructions above . I also attached the snap shot . But unable to get the required output .Start of the program was printing the hello message in pca10056 SDK but when converted ti pca10100  get no output to serial port . Although , i tested other programs examples for pca10100 they are displaying the startup message on serial terminal .

Your suggestions are very precious for me .Thanks in advance