Strange debug behaviour in SES

[Kampino]

Hi,

I messed up my SES project and now the debugging session doesn´t start and the debugger does some weird stuff and doesn´t execute my application.

I also tested if the error does exist in the example projects from Nordic and the problem doesn´t exist. So I think I have some issues in my project configuration.

[Vidar Berg]

Hi,

To see if it fixes the problem, please try to do a full chip erase, then re-program the applicaiton FW. From the screenshots it looks like the program is stuck at the beginning of flash, and probably not reaching your main() function.

Best regads,

Vidar

[Kampino]

Hello, I run "Target" -> "Erase all" and start a new debug session and this happens:

[Kampino]

Edit: <The error is not gone>

[Vidar Berg]

Does your application use the Softdevice? It looks like it was not programmed in that case. Note that you can configure the SES project to load the Softdevice binary along with the application by pointing to the correct Softdevice as show by the image below.

[Kampino]

No, I´m not using the Softdevice

[Vidar Berg]

I'm not sure what could have caused the hardfault then. Does your application start at address 0x0 in flash?