Where can I find the Header File for the nRF52833 ADAA SOC

[RussM]

I'm specifically interested in the predefined SPIMn - SCK, MOSI, MISO, SO pins for this device, so that I can marry this information into my CPU Schematic Page.
Whilst the Table 40: QFN40 Pin Assignments, there is a Note: If SPIM0, SPIM1, or SPIM2 is used with 8 Mbps data rate, the recommended GPIOs for the
clock signal (SCK) are P1.09, P0.04, and P0.31.

Usually, the Header File defines the parameter and pin for each of these SPIMn signals.  The PCA010100.h file bares no resemblance to the 40-pin QFN40 device.

Your assistance would be appreciated

RussM

[RussM]

Jared,

Thanks for that, I feel a lot better with my design, I was dreading getting a prototype PCB and found that nothing works.

I'll make a customised copy of the PCA10100.h file for when I test the Prototype PCB.

I was finalising my design, and wanted to have most of the code common to the nRF52833 DK

Regards
RussM

[Jared]

Sounds good! Also, if you're not aware: We offer free design reviews, just create a new Private ticket and attach your Schematic and PCB layout files and one of our HW engineers will take a look at it.

regards

Jared