nrf9160-dk spi clock configuration problem

[paul_tanner]

I made an own SPI device driver using the SDK's BM280 as a pattern

The result has a strange clock configuration (normally high - should be normally low)

Looking through other SPI drivers I do not see where this is coming from.

Is there an example of a *simple* spi driver that I can look at to see SPI clock configuration done right?

[Hakon]

Hello,

you can look at this sample 7167.spi_test.zip. It shows the correct configurations.

[paul_tanner]

Many thx Hakon,

That example was what I needed to properly configure the CS pin.

(I still have an issue of compatibility with an alternative app for nrf52 but that's a separate matter.)