Glitch in analog audio output when using I2S module

[cory123]

Hello.

I'm using the NRF52832 with I2S module connected to TLV320DAC from TI. I've configured the DAC and I2S module successfully. I'm getting audio output (simple sine wave read from a table) but there is an impulse glitch in the audio signal. The glitch appears to occur at the end of every I2S buffer send. When I set the I2S TX buffer size to 250 samples, I see a glitch in the audio at the corresponding time interval. For example, 250 buffer size at 41666 sample rate, causes a glitch in the audio every 0.006 seconds. When I increase the I2S buffer size, the glitch period increases correspondingly.

I've checked my sine table interpolation algorithm. It looks good. I believe the problem is with the NRF52832 and not the DAC. The I2S buffer size is the only variable which seems to affect the audio glitch. Oh, I also tried using I2S slave mode where I program the DAC to send the I2S clocks to the NRF chip. That did not change the glitch though.

I recorded the audio output in Audacity. Take a look at the waveform and frequency spectrum...

\

[cory123]

After some experiments, I found that you must use a double buffered scheme. This is not mentioned in the documentation and not too obvious from the single I2S example. The two sample buffers need to be passed in one when starting I2S and the other inside handler, the first iteration.