This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Glitch in analog audio output when using I2S module


I'm using the NRF52832 with I2S module connected to TLV320DAC from TI. I've configured the DAC and I2S module successfully. I'm getting audio output (simple sine wave read from a table) but there is an impulse glitch in the audio signal. The glitch appears to occur at the end of every I2S buffer send. When I set the I2S TX buffer size to 250 samples, I see a glitch in the audio at the corresponding time interval. For example, 250 buffer size at 41666 sample rate, causes a glitch in the audio every 0.006 seconds. When I increase the I2S buffer size, the glitch period increases correspondingly.

I've checked my sine table interpolation algorithm. It looks good. I believe the problem is with the NRF52832 and not the DAC. The I2S buffer size is the only variable which seems to affect the audio glitch. Oh, I also tried using I2S slave mode where I program the DAC to send the I2S clocks to the NRF chip. That did not change the glitch though.

I recorded the audio output in Audacity. Take a look at the waveform and frequency spectrum...


Parents Reply
  • Thanks for that Kenneth. Yes, I sort of barged my way into this thread not realising how isolated the nRF5 world was from the NCS world, so I'm sorry for the confusion.

    I appreciate that list of CONFIGs. Haven't been burnt so bad stepping into the unknown so many times in this project so far, I'm going to tread very carefully. Every CONFIG seems to have unintended consequences that soak up precious hours. So to be honest, unless a compelling reason comes up, or some really good documentation, I'm going to leave sleeping dogs lie! Great to have them to refer back to though.

No Data