Changing the transmission power with every set of 3 advertising messages

[Sarah]

Hi,

I would like to change the transmission power of the beacon kit so that I can switch back and forth between high and low tx powers for each set of advertising messages (3 messages sent on3 different channels). That is, after sending 3 messages on channels 37,38,39 with low transmission power, I would like to switch to high transmission power for the next three messages and so on.
How should I go about doing that? All I've figured out so far is that I should use sd_ble_gap_tx_power_set() function.

Thanks!

[RK]

Look at the section on radio events in the softdevice manual. You can get a signal at the end of a radio event. So subscribe to the radio events when you start advertising, each time one ends then you change your advertising power. When you go into connection or stop advertising, turn the events off again.

[Sarah]

Thanka @rols. Are you referring to table 15 in the manual by "timings beneath"? In that table, depending on the t_interval and t_ndist, different number of packets can be transmitted. I don't get why you're saying it's 3 for sure. Could you please elaborate?