hi all,
1. may i know how to get started of designing an AOA, mainly on how to send a CTE packet from TX to RX is there any code base or command that i can use?
2. i had noticed on the nWP-036_whitepaper, i don't really understand the steps of 5.1 transmitter and receiver config. can you kindly explain more clearly ?
thank you!
Hi Zack
I've done a test on my end, and did not have any issues seeing it advertising on my Nokia 8.1 when flashing the application onto my nRF52833 DK. If you're using some other HW, that might be why you're not able to see the advertisement due to either a bad antenna or an LF clock not available in your HW.
Best regards,
Simon
Hi Simon,
i also flashed the project into nRF 52833 DK. but i just can't get to show advertising beacon in my iPhone. is there any possible reason for it ?
1. A command that missed out ? (but if i missed out a command , i don't think i will be able to build up the project successful)
2. i tested with other BLE application , nRF52833 DK works out good. so i don't think there are problems with the board.
3. procedure on building up the project ? (rebuild project >> Debug(GO) >> RUN)
4.
Hi Simon,
i also flashed the project into nRF 52833 DK. but i just can't get to show advertising beacon in my iPhone. is there any possible reason for it ?
1. A command that missed out ? (but if i missed out a command , i don't think i will be able to build up the project successful)
2. i tested with other BLE application , nRF52833 DK works out good. so i don't think there are problems with the board.
3. procedure on building up the project ? (rebuild project >> Debug(GO) >> RUN)
4.
