Start AOA settings

[Zack_Lee]

hi all, 

1. may i know how to get started of designing  an AOA, mainly on how to send a CTE packet from TX to RX is there any code base or command that i can use?

2. i had noticed on the nWP-036_whitepaper, i don't really understand the steps of 5.1 transmitter and receiver config. can you kindly explain more clearly ?  

thank you! 

[Simonr]

Yes, I tested this on an nRF52833DK myself. Are you able to flash the .hex file onto the nRF52833DK successfully? Please upload a log from the nRFConnect Programmer as well as a screenshot of the GUI so I can have a look.

I will try to track down a v0.9.0 PDK like the one you have as well to test on to make sure that the DK version isn't the issue as well. It shouldn't be, but I'll check just in case.

Best regards,

Simon

[Zack_Lee]

Hi Simon,

im able to flash onto nRF52833DK (i think) 

i think there is no problem with flashing it. but it just can't get the advertising going!!! 

are there any extra steps?

1. pull .hex to programmer

2. erase the board

3. write into the board. 

DONE?

[Simonr]

That should be it indeed. Are you able to use anything else than the phone you have for a scanner? If you have another DK you should be able to see it using the Bluetooth Low Energy nRFConnect Desktop app.

Best regards,

Simon